Cable

HOW TO ASSEMBLE

On the cables, we’ll use the male connectors. With the one we used (DC connector) is very easy to do. Detach the cap and solder the positive cable in the smaller pin and the negative on the bigger. Repeat this at the other end and you’re ready. Do not forget to put the caps on the cable before soldering the other end.

If you use new cables, we suggest using superglue to hold the plastic, because this kind of screw opens very easily when using. Test it before gluing.

We recommend doing cables on different sizes and using a double wired cable, that is, the ones that comes with both cables (the one we’ll use for positive and the one we’ll use for negative) connected, this way it won’t look bad as the one in the image. But if you really want to save and will use our Ethernet cable tip (see in ‘how to save’ section), you can use a heat-shrink tube. For this width, the tube is really cheap.

If you’re using another kind of connector, visit ‘other connectors’ section.

watch the video

HOW TO TEST